| 
Applications
Specifications
Detection depths
Controls and Connectors
Coils, services etc.
|
Controls
and Connectors
The
power source of the LPX 2 is located on the bottom of the control
box. Please make sure that 10 x AA cells are put in the battery
holder. To open the unit simply press both knobs at the side of
the control box simultaneously. Please do never connect a charger
unit to the LPX2 while having non rechargeable batteries in the
battery compartment. Please do read the instructions of the manufacturer
of the recharging unit first!
While connecting the search coil connector to the electronics
unit and putting the AUDIO - control from the OFF- Position to
the marked position, the LPX 2 is turned ON. The Power source
will be disconnected automatically when the search coil - connector
is disconnected from the electronics unit.
AUDIO- control changes the ticking rate from silent to a low frequency
audio tone of the LPX 2 and also acts as a sensitivity control.
ZERO - pushbutton retunes the electronics to the set AUDIO- response
while pressing it for about two seconds before starting to search.
While pressing this control no metal should be in the near of
the search coil.
FREQ. - Frequency control changes the operation frequency of the
LPX 2 and should only be altered when power lines ore radio transmitters
interfere with the LPX2.
HEADPHONES - jack ...Any stereo headphones with 1/4 inch (6,35mm)
plugs can be connected to this jack. The built - in loudspeaker
will be automatically turned off when headphones are connected.
CHARGER - jack ...Please do only connect a charger (10 cell AA
- type) when rechargeable batteries are applied to the LPX 2 to
avoid explosions!
AUDIO - Beep sound ...will give an audible alarm when the batteries
are discharged. |
